Control and Instrumentation Engineer for Project Engineering
Larsen & Toubro
Chorasi, Gujarat, India1h agovia LinkedIn
About the Role
Control and Instrumentation (C&I) Engineer for Project Engineering at Larsen & Toubro.
Key Responsibilities
- Knowledge of Engineering and Site commissioning of Control & Instrumentation Packages including:
- Turbine Control System (TCS)
- Turbine Protection System (TPS)
- Turbine Supervisory Instrument (TSI) System
- Data Acquisition System
- Pneumatic control valves
- Field instruments, LIE/LIR
- Instrument hook ups
- Cables
- PG Test Monitoring System
- Preparation and review of P&ID diagram.
- Preparation of datasheets for Field instruments, Special instruments, JB, Cable trays, Instrument fitting.
- Preparation of instrument index, I/O list, Cable schedule, Junction box schedule, Wiring diagram, Termination Diagram, Instrument hookup drawing, Instrument location drawing, Earthing layout, Control schematic diagram, and loop diagram.
- Preparation of design basis and control philosophy for instrumentation process systems and packages/skids.
- Review and preparation of material requisition/RFQ, vendor offer evaluation, technical bid analysis.
- Review of vendor documents such as instrument datasheet, Panel wiring, Panel GA drawing, Power calculation, Earthing drawing.
- Preparation and review of PLC Architecture, I/O mapping, review of PLC panel wiring and GA drawing, and HMI and SCADA graphics.
- Coordination with other disciplines: Electrical, Mechanical, Process, and Civil for instrumentation interfaces.
- Coordination with external stakeholders: vendor, clients, and consultants.
- Control and Protection logic for steam turbine.
- Conducting Factory acceptance test (FAT).
- Conducting Site acceptance test (SAT).
- Site support during:
- Instrument installation
- DDCMIS (TCS, TPS) commissioning
- TSI system commissioning
- Unit startup
- Overhauling
- Willing to travel as required for job responsibilities (approximately 40%).
Requirements & Tech Stack
- Control and Instrumentation (C&I) Engineering
- Turbine Control System (TCS)
- Turbine Protection System (TPS)
- Turbine Supervisory Instrument (TSI) System
- PLC
- HMI
- SCADA
- P&ID
- Datasheets
- Field Instruments
- Control Valves
- Wiring Diagrams
- Loop Diagrams
- Factory Acceptance Test (FAT)
- Site Acceptance Test (SAT)