Autonomous Vehicle Technician

Autonomous Vehicle Technician (Level I)

Description

The AV Fleet Technician I supports daily readiness of autonomous vehicle data collection fleets through routine inspection, sensor cleaning, calibration, and vehicle turnaround. This contractor role follows established SOPs and escalates exceptions.

Key Responsibilities

• Perform routine vehicle inspections, sensor cleaning, and basic upkeep.
• Set up targets and execute documented sensor calibration and alignment procedures.
• Run prescribed validation checks and record pass/fail results.
• Perform basic cable, connector, and component inspections.
• Support documented sensor swaps and vehicle preparation.
• Record work, calibration results, and vehicle status in tracking systems.
• Escalate failed calibrations, unexpected alerts, and undocumented faults.
• Basic Linux Operations: Use basic Linux command-line tools (e.g., SSH, SCP) to access vehicle systems, execute prescribed commands, transfer files, and perform basic troubleshooting.

Minimum Qualifications

• Valid driver’s license.
• High school diploma or equivalent.
• Ability to follow detailed technical SOPs and document results accurately.
• Basic familiarity with Linux command-line operations, including SSH, SCP, file navigation, and execution of documented commands.
• Basic computer proficiency and hands-on mechanical or electronics aptitude.
• Attention to detail, dependable execution, and clear communication.

Preferred Qualifications

• Experience in automotive service, manufacturing, technical warehouse operations, or electronics assembly.

---

[EXPERIENCE: startExp=3, endExp=null]

Autonomous Vehicle Technician (Level II)

Description

The AV Fleet Technician II maintains AV fleet readiness by performing sensor calibration, hardware validation, software provisioning, and intermediate diagnostics. This contractor resolves known technical issues independently and supports Technician I escalations.

Key Responsibilities

• Execute and troubleshoot camera, LiDAR, radar, and IMU calibration workflows.
• Diagnose common sensor faults, harness/connectivity issues, and calibration failures.
• Perform hardware replacement, component checks, and validation tests.
• Monitor alerts and tickets, coordinate with remote engineering, and restore vehicles to service.
• Document findings and provide technical guidance to Technician I contractors.
• Escalate complex or undocumented failures to Technician III or engineering.
• Linux Diagnostics & Troubleshooting: Independently use Linux CLI tools (e.g., SSH, SCP, systemctl, journalctl, ip, ping) to diagnose connectivity, service, and system issues; review logs, execute diagnostic scripts, and perform software/firmware provisioning to resolve common AV system and calibration failures.

Minimum Qualifications

• Valid driver’s license.
• 3+ years in hardware maintenance, electronics troubleshooting, robotics, automotive electronics, or comparable work.
• Working proficiency with Linux CLI, including remote access (SSH/SCP), log analysis, service management, network diagnostics, and execution of Bash/Python scripts for troubleshooting and validation.
• Ability to interpret diagnostic outputs and technical documentation.
• Experience with software/firmware provisioning or hardware validation.

Preferred Qualifications

• AV/ADAS, robotics, LiDAR, radar, camera, GPS/IMU, or CAN bus exposure.
• Automotive Ethernet, FAKRA, and harness experience.

---

Scope and Expectations

• Execution-focused; does not independently diagnose complex or undocumented system failures. (Level I)
• Independently resolves known issues; escalates system-level and undocumented integration problems. (Level II)

Work Environment and Physical Demands

• Entirely onsite at a local warehouse, depot, or garage.
• Moderate physical activity, including lifting up to 40 lbs, bending, and working around vehicles and calibration rigs.
• May require alternative shifts or weekend coverage based on fleet schedules.