Line Operator, Anodize

About the Role

Pioneer Metal Finishing is seeking a Line Operator - Anodize for the 1st Shift (6:00 AM - 2:30 PM, Monday-Friday), with occasional Saturdays as needed. This is a safety-sensitive position.

Key Responsibilities

• Inspect loads for identification, tooling, security, heights, and depth location prior to picking them up.
• Coordinate loads with the Team Lead/Shift Supervisor to maximize tank efficiency and utilize open tank time.
• Ensure a program exists before processing loads; contact Team Lead/Supervisor if none is available.
• Process raw aluminum parts/loads between chemical finishing tanks using precise specifications and proper communication.
• Operate multiple lines where applicable.
• Strive for consistency from load to load and shift to shift through communication and teamwork.
• Ensure product is processed according to the program and meets required standards/specifications.
• Identify and escalate issues with product in the raw state, notifying the supervisor of problems such as excessive oil, deep and blind holes, areas that may trap air, corrosion, or galvanic reactions.
• Recommend process adjustments to meet end product specifications.
• Participate in tank maintenance activities.
• Reject any loads that do not meet standard processing requirements.
• Monitor pH and solution levels in tanks, making additions as required by daily checklists and procedures.
• Advise the lab if non-conforming tanks are found.
• Change tank filters when required.
• Respond to alarms and follow applicable protocol.
• Monitor the proper functioning of the waste treatment system if applicable.
• Operate standard equipment such as rectifiers, pumps, and cranes.
• Understand setup calibrations and basic troubleshooting for equipment including data tracks and controllers.
• Document and maintain accurate information on run sheets, including correct temperatures, loads, voltages, etc.
• Provide proper shift handoff and maintain consistency between shifts.
• Keep all work areas and equipment clean, safe, and orderly.
• Clean contact pads on work bars and tanks to ensure full electrical contact through loads.
• Immediately report any equipment problems via the designated procedure.
• Escalate any issues or ideas for tooling and improvement.

What to Expect on the Job

• Exposure to sharp parts, sharp tooling, heavy carts, occasional hot and cold temperature and humidity levels, heat from ovens, moderate noise levels, limited hand and air tool use, and compressed air (hearing protection required).
• Potential splash exposure near process lines.
• Various chemicals used in the process.

Requirements & Tech Stack

• Ability to operate standard equipment such as rectifiers, pumps, and cranes.
• Understanding of setup calibrations and basic troubleshooting for equipment including data tracks and controllers.
• Ability to read and understand work orders and safety instructions.
• Ability to communicate effectively in English.
• Ability to lift 30-50 lbs. unassisted.
• Ability to differentiate between color variances.

Qualifications

• Entry-level candidates welcome — no prior manufacturing experience required.
• Prior experience working with chemical processing or plating experience is a plus (higher wage offered).
• Strong work ethic and positive attitude.